Here is the in-training form of Impmon. I enjoyed making this one, especially the ears.
Abbreviations
stst = Stockinette stitch. Knit being the right side and Purl being
the wrong side.
Kfb = Knit front and back into a stitch to increase.
K2tog or P2tog = Knit or Purl 2 stitches together to decrease
B and T = break of yarn leaving a long end and thread through sts
left on the knitting needle and pull tight to close the hole then
fasten off
If knitting in the round divide the stitches equally
among the needles and when it says to Purl a row Knit instead. Stuff
as you go.
Head (Purple)
make 1
Cast on 6 sts
Purl
Kfb to last st (12sts)
Purl
(k1,kfb) to last st (18sts)
Purl
(k2,kfb) to last st (24sts)
Purl
(k3,kfb) to last st(30sts)
Purl
(k4,kfb) to last st(36 sts)
Purl
(k5,kfb) to last st(42sts)
Purl
(k6,kfb) to last st(48 sts)
Purl
(k7,kfb) to last st (54 sts)
Purl
(k8,kfb) to last st (60 sts)
Purl
(K9,kfb) to last st (66 sts)
Stocking stitch 10 rows beginning with a Purl row
(k9,k2tog) to last st (60 sts)
Purl
(k8,k2tog) to end (54 sts)
Purl
(k7,k2tog) to last st(48sts)
Purl
(k6,k2tog) to last st(42sts)
Purl
(k5,k2tog) to last st(36sts)
Purl
(k4,k2tog) to last st(30sts)
Purl
(k3,k2tog) to last st(24sts)
Purl
(k2,k2tog) to last st(18sts)
Purl
(k1,k2tog) to last st(12sts)
Purl
(k2tog) to last st(6sts)
B and T
Sew up the back seam stopping about 2 inches from the bottom to stuff
, just before you finish sewing up put more stuffing in the bottom to
make it rounder.
Ear's (Purple)
make 2
CO 6
Purl
(K1,kfb) to end (9 sts)
Purl
(k2, kfb) to end(12 sts)
stst for 7 rows beginning with a Purl row
Purl
(k2, kfb) to end(12 sts)
stst for 7 rows beginning with a Purl row
(K3,kfb) to end (15 sts)
Purl
(K4,kfb) to end (18 sts)
Purl
(K5,kfb) to end (21 sts)
stst 8 rows beginning with a Purl row
Cast Off
Sew up the back seam then stuff, pin in place on top of head to get position right then sew the Cast off edge to the head. Bend the tops slightly to form the ear bends.
Sew up the back seam then stuff, pin in place on top of head to get position right then sew the Cast off edge to the head. Bend the tops slightly to form the ear bends.
Face
Using light brown felt cut out the face. I found putting pins in
place on the head and drawing on a piece of paper to map out the face
to get it to the right size helpful, I then pinned the paper template
on to the felt to cut round. Do the same with the Eyes using white
for the eyeball and green for the iris. Pin the iris's on to the
eyeball's and then sew on using a matching green thread. Then pin the
completed eyes on to the face and sew on using white thread. Pin the
face on to the head using the pins you used to map out the face and
then sew on using a matching brown thread.
Yaamon
and Digimon are copyright of
Bandai/Toei Animation .
No comments:
Post a Comment